Differences

This shows you the differences between two versions of the page.

--- en:roadbook-designer-organizadores:edicion-del-roadbook:cambiar-medidas-y-medias [2026/03/13 18:34] – creado - editor externo 127.0.0.1
+++ en:roadbook-designer-organizadores:edicion-del-roadbook:cambiar-medidas-y-medias [2026/09/28 10:09] (current) – editor externo 127.0.0.1
@@ Line 1: / Line 1: @@
 ====== Change Measurements and Averages ======
-{{youtube>YN9MZv29WUc?large}}
+==== Changing the distance of a reference ====
+<WRAP box noteyellow>
+  - Tap the first box of the reference to open the [[en:roadbook-designer-organizadores:edicion-del-roadbook:editor-de-referencia|Reference Editor]].
+  - Type the new distance and tap **OK**.
+  - The Designer asks whether you want to add the difference to all the following references. Answer **Yes** if the rest of the stage is shifted by the same distance.
+</WRAP>
+==== Changing an average ====
+<WRAP box noteyellow>
+  - Tap the first box of the reference where the stage starts (the one that shows the average, for example S50).
+  - Type the new average and tap **OK**.
+</WRAP>
+To add an **average speed change** in the middle of a stage, open the Reference Editor of the reference where the average changes and type the new average: that reference starts a new stage. To remove an average speed change, hold the first box of that reference for 1 second.
+==== Changes to the whole roadbook ====
+Holding the **Add reference** button (6) for 1 second opens a menu with tools that change the whole roadbook at once:
+  * **Adjust references distances (%)**: multiplies all distances by the percentage you enter. 100 leaves the distances as they are, 101 increases them by 1 % and 99 reduces them by 1 %. Useful if you measured the route with the wrong calibration.
+  * **Adjust speeds (%)**: multiplies all the averages of the speed (S) stages by the percentage you enter. For example, 90 lowers all the averages by 10 %.
+  * **Convert metric units (Km/h) to imperial (MPH)** and **Convert imperial (MPH) units to metric (Km/h)**: convert the distances and the averages.
+  * **Mark as WPT based on GPS error (mts)**: marks as WPT the references whose GPS position has an error smaller than the one you enter, and unmarks the rest.
+<WRAP caution>
+These tools change the whole roadbook and are saved straight away. Save the RBD file before using them, in case you need to go back.
+</WRAP>
+==== Link times ====
+To make all the timed stages start on the full minute, use the **Adjust link times** button (8). See [[en:roadbook-designer-organizadores:convertir-roadbook-a-pdf-y-otros:grabar-y-enviar-el-archivo-rbd|Save and Send the RBD File]].
+**Video tutorial:**
+{{youtube>YN9MZv29WUc?large}}