Change Measurements and Averages [Rabbit Docs]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Change Measurements and Averages ======

==== Changing the distance of a reference ====

<WRAP box noteyellow>
  - Tap the first box of the reference to open the [[en:roadbook-designer-organizadores:edicion-del-roadbook:editor-de-referencia|Reference Editor]].
  - Type the new distance and tap **OK**.
  - The Designer asks whether you want to add the difference to all the following references. Answer **Yes** if the rest of the stage is shifted by the same distance.
</WRAP>

==== Changing an average ====

<WRAP box noteyellow>
  - Tap the first box of the reference where the stage starts (the one that shows the average, for example S50).
  - Type the new average and tap **OK**.
</WRAP>

To add an **average speed change** in the middle of a stage, open the Reference Editor of the reference where the average changes and type the new average: that reference starts a new stage. To remove an average speed change, hold the first box of that reference for 1 second.

==== Changes to the whole roadbook ====

Holding the **Add reference** button (6) for 1 second opens a menu with tools that change the whole roadbook at once:

  * **Adjust references distances (%)**: multiplies all distances by the percentage you enter. 100 leaves the distances as they are, 101 increases them by 1 % and 99 reduces them by 1 %. Useful if you measured the route with the wrong calibration.
  * **Adjust speeds (%)**: multiplies all the averages of the speed (S) stages by the percentage you enter. For example, 90 lowers all the averages by 10 %.
  * **Convert metric units (Km/h) to imperial (MPH)** and **Convert imperial (MPH) units to metric (Km/h)**: convert the distances and the averages.
  * **Mark as WPT based on GPS error (mts)**: marks as WPT the references whose GPS position has an error smaller than the one you enter, and unmarks the rest.

<WRAP caution>
These tools change the whole roadbook and are saved straight away. Save the RBD file before using them, in case you need to go back.
</WRAP>

==== Link times ====

To make all the timed stages start on the full minute, use the **Adjust link times** button (8). See [[en:roadbook-designer-organizadores:convertir-roadbook-a-pdf-y-otros:grabar-y-enviar-el-archivo-rbd|Save and Send the RBD File]].

**Video tutorial:**

{{youtube>YN9MZv29WUc?large}}