Start Time

Elements of the Start Time screen.

Start Time
Manual start (gets the current day and time)
Set the time for the next 30s (e.g.: 11:28:30)
Set the time for the next 1m (e.g.: 11:29:00)
Select the rally day
Option to reset the odometer when saving the data
Save start time

To configure the start time we depend on the information provided by the rally organization, which can be: Digital roadbook or Average speed table.

1. Open the menu and select Navigation (Roadbook screen).
2. Click on the red clock.

3. Enter the start time.
4. Verify the rally day.
5. Click on Save Start Time.

6. Place the car at the start location.
7. Reset the odometer by clicking on the blue rabbit.
8. Wait for your start time and Go!

For Monte Carlo start, simply click on the red rabbit of the corresponding stage and follow the same steps described above. To make it easier you can use the +30s or +1m buttons, depending on the rally regulations.

Important! If for any reason the rally organization changes the start time of the rally or a stage, you can change it simply by clicking on the corresponding red clock and following the same steps described above.

If the rally organization only provided the average speed table, we have two options to configure the start time. Either by pre-configuring the start time for each stage as described in the Stage Editor (Basic), or by adjusting it on the navigation screen.

To adjust the start time on the navigation screen, just follow the steps below.

Open the menu and select Navigation (Reg. Numbers screen).
Click on the chronometer.

3. Enter the start time.
4. Verify the rally day.
5. Click on Save Start Time.

6. Place the car at the start location.
7. Reset the odometer by clicking on it.
8. Wait for your start time and Go!